New Table Rails For MFT800?

[darita]

I just got a used MFT800 and found that the table rails are a little worse for wear.  They function fine, but I'd love to get some new side rails for the table, so that it matches the condition of my MFT1080.  Does anyone know where I can find these?  I tried to look them up on EKAT, but was unsuccessful.

 

[builderbob]

I have two of the profiles from an MFT 800. Not sure if they're the long or short. Let me know which you're looking for and I'll check when I get to the garage later on!

 

[tbellemare]

The 800 mm profile is 439098.

Tom

 

[builderbob]

I'm still not home, but it's coming back to me. I converted an MFT 800 to a 1080...in doing so, I used the longer 800 profiles as the shorter side of the 1080. I still have the shorter ones. If you're looking for all four, I have two and Tom just provided the longer part #'s!

Bob

 

[darita]

Bob and Tom,
Thanks so much for the help.  For some reason, when I go to look up the parts, the diagram doesn't come up, so I can't find the parts.  What am I doing wrong?

 

[tbellemare]

I had the same problem with EKAT and don't normally have any problem with it?

I looked it up another way and I think the short profiles are 439097.

Tom

 

[darita]

Thanks so much.  I'll get on the phone to Festool, right now.  Thanks again!

 

[tbellemare]

I think they've gone home for the day...

Tom

 

[Administrator_JSVN]

I tried to look them up on EKAT, but was unsuccessful.

Seems there are some problems with EKAT right now. I have notified my colleague in Germany, but it will be tomorrow at the earliest before it's addressed. Sorry for the trouble.

Shane