Hello,
I have a TS55 with a guiderail. I use it a lot and I'm very happy with it, but.....
I have a little problem with the splinterguard at the end of the guiderail. It seems that the saw cuts more from the splinterguard at the end of the guiderail then in the middle? My cut is still straight, but the splinterguard is not anymore. It now becomes more difficult to position the rail on my workpiece because the splinterguard is not representative for the cut of the saw anymore. Next to that the chance on splinters is bigger, because there is some space (+/- 1mm) between the splinterguard and the saw.
I was wondering if other users have encountered the same problem? I'm pretty sure that I kept the saw straight on the rail, so I'm looking for what I'm doing wrong....
Grtz,
Daniel
I have a TS55 with a guiderail. I use it a lot and I'm very happy with it, but.....
I have a little problem with the splinterguard at the end of the guiderail. It seems that the saw cuts more from the splinterguard at the end of the guiderail then in the middle? My cut is still straight, but the splinterguard is not anymore. It now becomes more difficult to position the rail on my workpiece because the splinterguard is not representative for the cut of the saw anymore. Next to that the chance on splinters is bigger, because there is some space (+/- 1mm) between the splinterguard and the saw.
I was wondering if other users have encountered the same problem? I'm pretty sure that I kept the saw straight on the rail, so I'm looking for what I'm doing wrong....
Grtz,
Daniel