When fitting worktops, what is the general consensus of opinion on the use of Colourfill.
I have just started to fit them as I normally get them fitted by a contractor, but this time I have 26 to fit so decided to do them myself
They are in a dry classroom environment installed on cantilvever legs so no cabinets below, the legs are positioned so there is a leg directly below the joints.
The chance of getting wet it very small.
The first ones , so far I have just used waterproof PVA in the joint as it would add to the strength when dry.
Here is one I did yesterday, the joint runs side to side, half way up:
[attachimg=1]
I personally decided that the Colorfill would just make the joint more obvious, I would love to know what everyone else does
Regards
Dale
I have just started to fit them as I normally get them fitted by a contractor, but this time I have 26 to fit so decided to do them myself
They are in a dry classroom environment installed on cantilvever legs so no cabinets below, the legs are positioned so there is a leg directly below the joints.
The chance of getting wet it very small.
The first ones , so far I have just used waterproof PVA in the joint as it would add to the strength when dry.
Here is one I did yesterday, the joint runs side to side, half way up:
[attachimg=1]
I personally decided that the Colorfill would just make the joint more obvious, I would love to know what everyone else does
Regards
Dale