- Joined
- Sep 10, 2014
- Messages
- 239
Hi All,
I have finally gotten around to using the Parf Guide Mark 2 to create a couple of MFT/3 tops one traditional and one isometric. I used Osmo Polyx over a high grade of MDF prior to drilling the holes. I had some blowout issues on the underside when drilling the 20mm holes....otherwise it was a fantastically useful experience. FWIW, I did use my CXS which was not really challenged per se, but could have been a bit stronger. Anybody have any suggestions?
[jawdrop]