What table saw to complement MFT3?

[rst]

It is not difficult to modify the height on the MFTs, I have two and shortened both to 34 3/8" to be just below the height of my PM table saw and my self built router table.  All my equipment is movable, even my MFTs.  I installed DeStaco inline clamps to one narrow ends of my tables using heavy aluminum angle.  I replaced the 5/16" clamp end with post swivel casters.  They are adjusted so that when in lock them down I can pick up the other end and away I go.

 

[Holmz]

[member=20320]rizzoa13[/member] was kind enough to demo his Erika for me and I am sold. With the sliding table and pull-to-cut features it will replace a SCMS in a small shop and and I....
...

Comparing a saw stop and a Kapex cost with an Erika makes it look more compeditive.

The other option on an MFT is using some spacer to go from the dog holes for the slender cuts.
Then there is also hand plane, and one can probably do something with a router table and fence.

Hard to beat a table saw for those cuts though.

 

[Paul G]

It is not difficult to modify the height on the MFTs, I have two and shortened both to 34 3/8" to be just below the height of my PM table saw and my self built router table.  All my equipment is movable, even my MFTs.  I installed DeStaco inline clamps to one narrow ends of my tables using heavy aluminum angle.  I replaced the 5/16" clamp end with post swivel casters.  They are adjusted so that when in lock them down I can pick up the other end and away I go.

I thought the MFTs were quite adjustable but have no personal experience with them. If it's of any help to anyone, my SS Jobsite sits at about 35 7/8"