CMT Bits for Domino 500?

[sessler2013]

Anyone tried the CMT bits? If so how are they as far as cut quality, and longevity?

 

[builderbob]

I'm not sure of the longevity of the cmt variant for the domino but I can sure attest to the life of the Festool bit. I still have all of my originals that were purchased when the domino was released. Of those, I use the 5 & 6 mm the most and they're still going strong. Cost vs life has paid off many times over!

 

[tjbnwi]

I have the CMT 4 mm. Works fine, been using it since the 4 mm tenon was introduced.

Tom

 

[hrrb]

I haven't got CMT bits for my Domino.

But I have lots of CMT bits in general and I can only recommend them. Top quality! They have never let me down.

Next to Festool bits ( of course  [wink] ) CMT bits are my preferred bits.

Kind regards
Henrik

 

[sl_1800]

Just yesterday I trashed my Festool 5mm bit and my 6mm is a little ruff so I just ordered the CMT version of both, they should be here on Tuesday, weather permitting.

 

[jacko9]

Just yesterday I trashed my Festool 5mm bit and my 6mm is a little ruff so I just ordered the CMT version of both, they should be here on Tuesday, weather permitting.

Let us know how they hold up since you seem to be using these cutters pretty hard.

Jack

 

[sessler2013]

Just yesterday I trashed my Festool 5mm bit and my 6mm is a little ruff so I just ordered the CMT version of both, they should be here on Tuesday, weather permitting.

Let us know how they hold up since you seem to be using these cutters pretty hard.

Jack

Yea please do a follow up on the bits!

 

[tallgrass]

I have been using them for some time. I have found them to be excellent. I go through quite a few dominos.

 

[Slappy]

I got a full set of CMT's for my 500 , their great !