Does Anyone Make a Wide Bearing Router Bit

[Bob D.]

Was looking for a top bearing router bit with a wide (thick) bearing.
All the bits seem to have something with a 1/4" face that rides against
the template. Is there something in the 1/2" range or is there a bit that
will allow two bearings to be stacked together to form a wider surface?

You'll ask why would you need that but I can't go into detail yet.

 

[Roseland]

Like this?
https://routercutter.co.uk/up-cut-spiral-flush-trim

Andrew

 

[tjbnwi]

Stack two bearings or look for a bearing with the i.d. and o.d. you want in the height you want.

Either way make sure you have enough collet purchase on the shaft.

Tom

 

[rst]

UltraTrim™ Solid Carbide Spiral Trim Router Bits w/ Double Ball Bearings  - google this...I buy all my router bits and saw blades thru
toolstoday.com or routerbitworld.com

 

[Bob D.]

Like this?
https://routercutter.co.uk/up-cut-spiral-flush-trim

Andrew

Yes but bearings on the collet end of the bit. I didn't turn up any when I searched. Thanks.

 

[rmwarren]

Ditto what Tom said. ToolsToday is my go-to for bits and they have a nice assortment of cutter's, bearings, etc.

RMW

 

[Bob D.]

Thanks everyone. I went there and found what I think will work.

 

[rst]

Hope what you found works for you.  I also buy all the blades that I use in my 55, 75, and HKC from Toolstoday...AGE.