Festool OF1010 edge guide

[tjbnwi]

1010 with the 2200 fence and the 1010 fence, use the 8mm rod.

[attachimg=1]

[attachimg=2]

Tom

[eek]

But I guess this bends the rods like half a mm each? Does it sit sturdy?

Also; now I have to get a 2200 too $$

The set up does not bend the rods at all.

The setup is as sturdy as the assigned edge guides are.

Tom

 

[Michael Kellough]

[member=44099]Cheese[/member]  I think I see a spring washer in the Micro adjuster assembly. Is that washer easy to compress? Is there any lash or hesitation when turning the knob either way?

[attachimg=1]

 

[Cheese]

[member=44099]Cheese[/member]  I think I see a spring washer in the Micro adjuster assembly. Is that washer easy to compress? Is there any lash or hesitation when turning the knob either way?

[member=297]Michael Kellough[/member] If I remember correctly...and that's a big IF...lash was just a tad less than .001". If you need a more accurate answer, I can check it later on today.

 

[Michael Kellough]

[member=44099]Cheese[/member]  I think I see a spring washer in the Micro adjuster assembly. Is that washer easy to compress? Is there any lash or hesitation when turning the knob either way?

[member=297]Michael Kellough[/member] If I remember correctly...and that's a big IF...lash was just a tad less than .001". If you need a more accurate answer, I can check it later on today.

Found a post of yours in the “Woodpeckers Micro Adjust” thread. In reply #11 you said lash in the Micro-Fence was about .002”. Looks like you could tighten the nut a little more and reduce that?