PS 420 parallel side fence?

[Purre]

Hello
Are there any parallel side fence on the market for the PS 420?
The older Trion PS 300 have it and would be nice if the 420 also have it!

 

[MrToolJunkie]

Nope...and I think that this is one area where Festool dropped the ball. You have to use the guide rail or a straight edge if you need to make guided cuts.

 

[Purre]

But the guide rail is to big some times. A cms table would fix the problem but it is expensive

 

[PreferrablyWood]

you could buy a FS 1400 and cut it into a FS 600 and FS 800 pair...

 

[Purre]

I already have the fs 800 but it is not the lenght that is the problem, it is the width

 

[wow]

I admit that I have - once  [wink] - used the guide rail base and just run it along a straightedge as a guide.