es07Eric said:
Sparktrician said:
es07Eric said:
Is there a way to reference the "last pin" drilled. Specifically, if I need additional holes past what the 55" rail affords, how is the last pin referenced. I'm trying to avoid having to purchase a 95" rail as this requirement will only be needed in a few instances.
Thanks,
Eric
Why not just use two 1400 holy rails (496939)? They couple together well using the LR 32 Guide Rail Index (496938) to set the hole spacing dead nuts on the money. You don't need the longer "Holy" rail. When you join the two "Holy" rails, you get a longer rail (110") than just using the 95" "Holy" rain, and the 1400s are easier to store and transport.
This is BRILLIANT! Sometimes I have a hard time believing that not all solutions require complex configurations!
[thanks]
Just remember that you'll need two Guide Rail Connectors (482107) to join the rails and the LR 32 Guide Rail Index (496938) to set the hole spacing. Recommend that you also consider getting the
Betterley SLC23 StraightLine Connector for Guide Rails to help ensure that the rails are in perfect alignment. As for using one Holy rail with one standard rail, given that there's only $5 difference between the two, just get two Holy rails and be done with it. I'm into efficiency, not tedium. Sorry, fshanno.
And another thing, you might want to consider using the screws in
this message to replace the screws that come with the Guide Rail connectors. You'll need a 3mm hex wrench to tighten them.