I don't know if this belongs here or not but I couldn't see a better place to post it.
I think I know the answer to this but I was just wondering what you guys would do. I set up my MFT/3 and when I do the 5 cut check, the last cut is 17.6mm on the far end and 17mm on the near end. Dividing that by 4 gives me out of square by .15mm or 0.01" on a 14" cut. Would any of you try to tweak that closer or would you leave it as is?
Stan
I think I know the answer to this but I was just wondering what you guys would do. I set up my MFT/3 and when I do the 5 cut check, the last cut is 17.6mm on the far end and 17mm on the near end. Dividing that by 4 gives me out of square by .15mm or 0.01" on a 14" cut. Would any of you try to tweak that closer or would you leave it as is?
Stan