Lou in DE
Member
- Joined
- Apr 1, 2015
- Messages
- 100
I wanted to have the MFT level with the out feed table for my table saw - this meant dropping about 2 inches off the height. I did not want to cut the legs and since the MFT never leaves my shop, I just built a table for it at the right height. Since I needed a place for some Sys 5's that I had, I incorporated a couple of trays (and a couple of drawers) plus a little caddy on the side. This gives me a lot or real estate which comes in real handy - here are a few pics:



