I had a new idea how to build a proper extension to hold the Positioner or any other addition such as a router table. Using two of the MFT/3 connectors (just like the ones to connect two guide rails, but thicker) is one way or maybe half, because some feet would be needed to reinforce the extension to hold a router with table.
Buying the MFT/3 VL extension is possible (at least here in Europe), but then you would need the CMS Router module and your budget is already over the top for the MFT-VL. Since the CMS Module is pretty thin (aluminum) building or customizing your own router table top for the MFT Extension is probably not that easy because of this thickness. The only thing that could work is a proper sized aluminum plate, but then I guess you get near the cost for the Festool module.
While writing the review of the new Kapex extension KA-UG
Kapex Extension
and its additional use as an MFT/3 extension, I had the idea to order two of these feet and attach them to the router table top. Together with the MFT connectors on the other side you'll just need to adjust the thickness of the router table top to connect it with the MFT or maybe even add the KA-UG V attchement instead. I'll check out prices and post an update later.
[attachimg=1]
[attachimg=2]
[attachimg=3]
Buying the MFT/3 VL extension is possible (at least here in Europe), but then you would need the CMS Router module and your budget is already over the top for the MFT-VL. Since the CMS Module is pretty thin (aluminum) building or customizing your own router table top for the MFT Extension is probably not that easy because of this thickness. The only thing that could work is a proper sized aluminum plate, but then I guess you get near the cost for the Festool module.
While writing the review of the new Kapex extension KA-UG
Kapex Extension
and its additional use as an MFT/3 extension, I had the idea to order two of these feet and attach them to the router table top. Together with the MFT connectors on the other side you'll just need to adjust the thickness of the router table top to connect it with the MFT or maybe even add the KA-UG V attchement instead. I'll check out prices and post an update later.
[attachimg=1]
[attachimg=2]
[attachimg=3]