David2T370
Member
- Joined
- Dec 3, 2014
- Messages
- 50
Well - ever since I purchased my Kapex 120 EB, I have wanted to build a miter station for it. Currently it is balanced on two saw horses. The design I like the best is Peter Parfitt's design. I have taken the basic cabinet of his design and adapted it to my needs as far as working height and drawers, etc.
That being said, I set about drawing up as best I was able to, drawings and measurements to include a finished cut list (finished as in the final dimension). After drawing out all of the views and making the cut list you would think that I would be ready to start cutting, etc. Well, before I do that I want to know if what I have put down on paper and dimensions are accurate and will work as I intended.
What I am asking for - is there someone out there that would not mind looking at my plans with a fine tooth comb and locating any errors? I have scanned my plans, but not sure if they are appropriate to just include them on this post.
I am sure that there will be questions and explanations needed once looking at what I have. So, with that, I am looking for some help.
Thank you in advance,
David
P.S. Peter Parfitt, I hope I have done your plans justice in my conversion. No malice intended by changing them somewhat.
That being said, I set about drawing up as best I was able to, drawings and measurements to include a finished cut list (finished as in the final dimension). After drawing out all of the views and making the cut list you would think that I would be ready to start cutting, etc. Well, before I do that I want to know if what I have put down on paper and dimensions are accurate and will work as I intended.
What I am asking for - is there someone out there that would not mind looking at my plans with a fine tooth comb and locating any errors? I have scanned my plans, but not sure if they are appropriate to just include them on this post.
I am sure that there will be questions and explanations needed once looking at what I have. So, with that, I am looking for some help.
Thank you in advance,
David
P.S. Peter Parfitt, I hope I have done your plans justice in my conversion. No malice intended by changing them somewhat.
