TS55, OF1400 and OF1010 Imperial Depth Scale.

rsausa said:
TS75 labels next week ?  [eek]

Me too? (Not anxious, just excited because I understand measurements based on some ancient arbitrary distance versus measured science and logic). Can't wait.
 
Got my OF1400 label and the conversion labels for the rails, and they are great.

Will definitely order a label for the TS75 when available.

Steve
 
The TS75 scale looks to be a hard overlay to make.  [unsure]

This is the one I received from Tim.

[attachimg=#]

Maybe someone can contact him?

[attachimg=#]
 
I set my TS55 label to +8mm. Lined the zero on the label up with the 8mm mark on the saw.  +5mm for the rail and +3 for the tooth clearance.  That way I can really set it to the material thickness.  I am the only one to ever use the saw so if I cut  too deep by mistake it's my own fault.

Seth
 
overanalyze said:
I had to create an account just to say thanks! Just ordered one for my TS55!!

Welcome to the FOG!  [smile]

Seth
 
Welcome to the site Andrew.

Your label just went in the mailbox. I would guess you will have it the first of the week.

Rich

 
Rich,
Just wondering if the ATF scales worked out alright.  Mine works fine but haven't seen any other posts about it.

Rusty
 
Both my local dealers don't have TS75s in stock at the moment. So I am not making any progress!

I am looking for someone with a TS75 that is capable of printing PDF paper templates and helping me with this. If you can scan the paper next to a rule and email it back that would be even more helpful.  The closer to the Midwest the better as I can mail you labels without much delay.

Of course you will get labels for your 75 and whatever else I offer at no cost.

Rich
 
Great.

I was thinking about you today and was going to email you to make sure they came.

Thanks.

Rich
 
Did you find anyone to help with the TS75 label?  I'd be willing to if you haven't.
 
No, not yet.

And you are close too !

Drop me an email at r.mccabe@iowawebhosting.com

 
Back
Top